After adding and enabling a linkage rule
or exception rule, you need to make sure the Notification functionality of the
Source device is enabled so that the events detected by the device can be uploaded to the
Hik-Partner Pro system and the Hik-Connect Mobile Client. This is the
prerequisite to trigger the linkage actions and exception
rules defined in the Source-device-related linkage rule(s) and
exception rule(s) respectively.
Note:
The device should support this functionality.
If
you have activated the health monitoring service for the device, the
exception notification function of the device is enabled by default. For
details about activating the health monitoring service, refer to Activate the Health Monitoring Service.
-
Tap a site to enter the site details page.
-
Select the Device tab.
-
Tap a device to enter the device details page.
-
Tap to enter the Notification Settings page.
-
Set the parameters.
- Notification
-
Make sure the functionality is enabled.
- Notification Schedule
-
After enable the Notification functionality, set a
time schedule for uploading the events detected by the
Source.
You can select date(s) and then set the start time
and end time for each selected date.
-
Tap OK.
Note:
-
Please notify the end user after handing over the
site to him/her that notification of the Source should be kept
enabled on the Hik-Connect Mobile Client, or the Linkage Action will NOT
be activated no matter the Triggering Event is detected by
Source or not. For details about enabling alarm notification for
a specific device or channel, see the Hik-Connect Mobile
Client User Manual.
-
Please notify your end users to download or update
the Hik-Connect
Mobile Client (V 4.15.0 or later). You can send the QR code or
download link shown in the banner on the Home page of Portal to
them.
> Notification to enter the Notification Settings page.