Batch Activate Devices and Assign IP Addresses for Them

The Mobile Client can detect available devices connected to the same network with the client, and you can activate devices and assign IP address for them.

Make sure the devices you are going to use are correctly installed and connected to the network as specified by the manufacturers.

  1. On the Home page, tap On-Site Config or More > Tools > On-Site Config to enter the configuration page.
  2. Optional: Tap Show Inactivated Devices Only to hide the activated devices.
  3. Select the detected online devices to be activated.
  4. Tap Activate and Assign IP Address to open the Activate and Assign IP Address window.
  5. Enter the device admin password and confirm the password.
  6. Tap Activate and Assign IP Address.
    Note:

    • The unactivated device and the activated device but not be assigned with IP address will be displayed as Not Obtained in the Device Name column.

    • For the activated device and be assigned with IP address, if you hover the mouse on the IP address, Auto will be displayed to remind you the IP address is automatically assigned.

    The devices are activated, and the device IP address, device port, HTTP port, subnet mask, gateway are assigned by the client.

    The time of the mobile phone will be synchronized to the activated devices.

  7. Optional: Enable Time Synchronization to synchronize the time from the mobile phone to the device.
  8. Tap OK.

After activating the devices, you should batch add channels to NVR and DVR. For details, refer to Batch Link Channels to NVR and DVR.