Add Devices After Batch Configuring Them on LAN

After batch configuring devices, you can batch add these devices to the Mobile Client.

1. Select a Site as the target to which devices will be added.
   Note:

   You can select an existing Site, or you can add a new Site. For details about adding a new Site, refer to Add New Site.

2. Select the device(s) to be added.
3. Tap Next.
4. Batch enter the device password, and tap Complete.
   Note:

   The password will be applied to all the devices to be added. You can also edit the password for a single device.

5. Tap Next.

   If there is a wrong password prompt, you can edit the password as prompted, or you can skip the prompt and go to the next step.

6. Configure device verification code.

   • Tap Configure Verification Code, and batch configure a verification code for all the devices.

     Note:

     You can customize the verification code as needed.

   • Tap Enter Verification Code, and enter the verification code for each device to be added.

     Note:

     You can get the verification code from the bottom of the device.

7. Tap Next.

   The device compatibility test starts.

   Note:

   Only when all devices' compatibilities have been tested, can you add them to Hik-Partner Pro.

8. Add devices.
   Note:

   For details about adding devices, see Add Device by Scanning QR Code or Add Device by Entering Serial No..

   • If there are no upgradeable devices, tap Add to add the selected devices.

   • If there are upgradable devices, tap Add and Upgrade to add all devices and upgrade the upgradable devices.

     Note:

     • If there are devices that failed to be upgraded, you can tap Details to view failure details.

     • Devices that failed to be upgraded can also be added to the target Sites.