You can set the access control device's linkage actions for the access control device's triggered event. After that, when an event is triggered, it can trigger the alarm output, buzzer on access controller, and other actions.

1. Click Physical View on the Home page, and then select Access Control Device.
2. Click to enter the remote configuration page.
3. Click Add on the Linkage section to enter the Linkage page.
4. Set event source.
   1. Select Event Linkage as the linkage type.
   2. Select an event type from the Event Type drop-down list and then select a specific event from the drop-down list besides.
      Note:

      • If you select alarm input event, you should select an alarm input.

      • If you select door event, you should select a door.

      • If you select a card reader event, you should select a card reader.

5. Configure linkage target.

   Buzzing

   If the specified event is triggered, the buzzer (buzzer on the access control device or card reader) will start buzzing or stop buzzing.

   Buzzer on Controller

   ON

   If the specified event is triggered, the buzzer on the access control device will start buzzing.

   OFF

   If the specified event is triggered, the buzzer on the access control device will stop buzzing.

   No Linkage

   This linkage action is disabled. The buzzer action will not be triggered when the specified MAC address is detected.

   Buzzer on Reader

   ON

   If the specified event is triggered, the buzzer on the selected card reader will start buzzing.

   OFF

   If the specified event is triggered, the buzzer on the selected card reader will stop buzzing.

   No Linkage

   This linkage action is disabled. The buzzer action will not be triggered when the specified MAC address is detected.

   Capture & Recording

   Check Capture to enable the device's linked camera to capture a picture when the specified MAC address is detected.

   Check Recording to enable the device's linked camera to record video footage when the specified MAC address is detected.

   Alarm Output

   ON

   If the specified event is triggered, the selected alarm output will be triggered.

   OFF

   If the specified event is triggered, the selected alarm output will be stopped.

   No Linkage

   This linkage action is disabled. The alarm output action will not be triggered when the specified MAC address is detected.

   Access Point

   Unlock

   If the specified event is triggered, the selected door will be unlocked.

   Lock

   If the specified event is triggered, the selected door will be locked.

   Remain Unlocked

   If the specified event is triggered, the selected door will remain unlocked.

   Remain Locked

   If the specified event is triggered , the selected door will remain locked.

   No Linkage

   This linkage action is disabled. The door action will not be triggered when the specified MAC address is detected.

6. Click Save.
7. Optional: Perform the following operations after adding a linkage

   Option	Description
   Delete Linkage Settings	Select the configured linkage in the linkage list and click to delete it.
   Edit Linkage Settings	Select the configured linkage in the linkage list and click to edit the linkage.