If you need to add multiple access control devices which have no fixed IP addresses and support ISUP 5.0 protocol to HikCentral Professional, you can add them to HikCentral Professional at a time after configuring a device ID segment for the devices.

1. Click Physical View > Access Control Device to enter the Access Control Device Management page.
2. Click Add to enter the Add Access Control Device page.
3. Select Hikvision ISUP Protocol as the Access Protocol.
4. Select Device ID Segment as the adding mode.
5. Enter the required parameters.
6. Set the Picture Storage switch to on to set the storage location for pictures.
   1. Select the storage device from the drop-down list.
   2. Select storage locations for face picture library and captured pictures.
      Note:

      You should store face picture library and captured pictures in the different locations.

7. Optional: Select a time zone for the device in drop-down list of Time Zone of Device.
   Note:

   You can check Apply to Device so that when the time zone of the device and the system are not consistent, the system will automatically apply the time zone settings to the device.

8. Optional: Switch Add Channel to Area to on to import the channels of the added devices to an area.
   Note:

   • You can create a new area by the device name or select an existing area.

   • For video access control terminal of a device, the camera on the terminal will also be imported to the corresponding area.

   • If you do not import any access point to an area, you cannot perform further operations for the access point.

9. Finish adding the device.

   • Click Add to add the access control device and back to the access control device list page.

   • Click Add and Continue to save the settings and continue to add other access control devices.