If the elevator control devices share a user name and password, and their IP address are in an IP segment, you can add them to the system by specifying the start IP address and the end IP address, user name, password, etc.
Make sure the elevator control devices you are going to use are correctly installed and connected to the network as specified by the manufacturers. Such initial configuration is required in order to be able to connect the devices to the HikCentral Professional via network.
By default, the device port number is 8000.
The password strength of the device can be automatically checked. We highly recommend you change the password of your own choosing (using a minimum of 8 characters, including at least three kinds of following categories: upper case letters, lower case letters, numbers, and special characters) in order to increase the security of your product. And we recommend you change your password regularly, especially in the high security system, changing the password monthly or weekly can better protect your product.
Proper configuration of all passwords and other security settings is the responsibility of the installer and/or end-user.
You can check Apply to Device so that when the time zone of the device and the system are not consistent, the system will automatically apply the time zone settings to the device.
You can create a new area by the device name or select an existing area.
If you do not import channels to area, you cannot perform further operations for the channels.
Enter the range of floor No. according to the application scene.
You can apply the floor name according to the floor range you set in the logical view.
Click Add to add the elevator control device and back to the elevator control device list page.
Click Add and Continue to save the settings and continue to add next elevator control device.
Option | Description |
---|---|
Remote Configurations |
Click Note:
|
Change Password |
Select the added device(s) and click
![]() Note:
|
Apply Application Settings |
After restoring the database or device's default
configurations, if the parameters (such as floor status settings and
card reader access mode) in the system are inconsistent with the
parameters on the elevator control device(s), a red icon |
If the elevator control devices share a user name and password, and their IP address are in an IP segment, you can add them to the system by specifying the start IP address and the end IP address, user name, password, etc.
Make sure the elevator control devices you are going to use are correctly installed and connected to the network as specified by the manufacturers. Such initial configuration is required in order to be able to connect the devices to the HikCentral Professional via network.
By default, the device port number is 8000.
The password strength of the device can be automatically checked. We highly recommend you change the password of your own choosing (using a minimum of 8 characters, including at least three kinds of following categories: upper case letters, lower case letters, numbers, and special characters) in order to increase the security of your product. And we recommend you change your password regularly, especially in the high security system, changing the password monthly or weekly can better protect your product.
Proper configuration of all passwords and other security settings is the responsibility of the installer and/or end-user.
You can check Apply to Device so that when the time zone of the device and the system are not consistent, the system will automatically apply the time zone settings to the device.
You can create a new area by the device name or select an existing area.
If you do not import channels to area, you cannot perform further operations for the channels.
Enter the range of floor No. according to the application scene.
You can apply the floor name according to the floor range you set in the logical view.
Click Add to add the elevator control device and back to the elevator control device list page.
Click Add and Continue to save the settings and continue to add next elevator control device.
Option | Description |
---|---|
Remote Configurations |
Click Note:
|
Change Password |
Select the added device(s) and click
![]() Note:
|
Apply Application Settings |
After restoring the database or device's default
configurations, if the parameters (such as floor status settings and
card reader access mode) in the system are inconsistent with the
parameters on the elevator control device(s), a red icon |