HikCentral Professional provides multiple modes for reading a card's number: via card enrollment station, via enrollment station, or via the card reader of the access control device. You can connect a card enrollment station to the PC running the Web Client, and place the card on it to read the card number. Or you can specify the IP address, port number, user name and password to access the enrollment station to enroll card number. You can also swipe the card on the card reader of the added access control device to get the card number. As a result, before issuing a card to one person, you need to set the card issuing parameters including the issuing mode and related parameters.
For entering the card issuing parameters settings page when adding single person, refer to Add a Person.
For entering the card issuing parameters settings page when issuing cards to persons in a batch, refer to Batch Issue Cards to Persons.
Connect a card enrollment station to the PC running the Web Client. You can place the card on the card enrollment station to get the card number.
If you select this mode, you should set the card format and card encryption function.
If the card is Wiegand card, select Wiegand. Otherwise select Normal.
If your card supports dual frequency (both IC and ID), you need to select Dual. Otherwise, select Single.
If you select Dual, you can not set card encryption for the card.
If you set the card format as Normal, you can enable the card encryption function for security purpose. After enabled, you should enable the card encryption in the access control device's configuration page to take effect.
Turn on or turn off the audio.
You can enroll the card number remotely via enrollment station and copy back to the system.
If you select this mode, you should set the required parameters as follows.
Select one card reader of one access control device added to the system. You can swipe the card on the card reader to get the card number.
One card reader can be set to issue card by up to one user at the same time.
If you set a third-party card reader to read the card number, you should set the device's custom Wiegand protocol to configure the communication rule first.
HikCentral Professional provides multiple modes for reading a card's number: via card enrollment station, via enrollment station, or via the card reader of the access control device. You can connect a card enrollment station to the PC running the Web Client, and place the card on it to read the card number. Or you can specify the IP address, port number, user name and password to access the enrollment station to enroll card number. You can also swipe the card on the card reader of the added access control device to get the card number. As a result, before issuing a card to one person, you need to set the card issuing parameters including the issuing mode and related parameters.
For entering the card issuing parameters settings page when adding single person, refer to Add a Person.
For entering the card issuing parameters settings page when issuing cards to persons in a batch, refer to Batch Issue Cards to Persons.
Connect a card enrollment station to the PC running the Web Client. You can place the card on the card enrollment station to get the card number.
If you select this mode, you should set the card format and card encryption function.
If the card is Wiegand card, select Wiegand. Otherwise select Normal.
If your card supports dual frequency (both IC and ID), you need to select Dual. Otherwise, select Single.
If you select Dual, you can not set card encryption for the card.
If you set the card format as Normal, you can enable the card encryption function for security purpose. After enabled, you should enable the card encryption in the access control device's configuration page to take effect.
Turn on or turn off the audio.
You can enroll the card number remotely via enrollment station and copy back to the system.
If you select this mode, you should set the required parameters as follows.
Select one card reader of one access control device added to the system. You can swipe the card on the card reader to get the card number.
One card reader can be set to issue card by up to one user at the same time.
If you set a third-party card reader to read the card number, you should set the device's custom Wiegand protocol to configure the communication rule first.