You can configure other parameters for the access control device, such as device time, skin-surface temperature and facial recognition mode.
The parameters may vary with different models of devices.
You can view the time zone where the device locates and set the following parameters.
Set Temperature Screening to on to enable temperature screening function.
Set the range of normal skin-surface temperature. The detected temperature which is not in this range is abnormal temperature. The maximum temperature should be higher than the minimum temperature.
If enabled, the door will open when person's skin-surface temperature is abnormal. By default, the door will not open for abnormal temperature.
Enter the device IP address of the linked thermal camera for temperature screening.
It is used for the access control devices that do not support temperature screening.
Set Mask Detection to on to enable mask detection function. Then the device can detect persons with no masks.
You can configure passing mode for the turnstile linked to the device.
The device will follow the lane controller's DIP settings to control the turnstile. The settings on the main controller will be invalid.
The device will follow the settings of main controller to control the turnstile. The DIP settings of the lane controller will be invalid.
You can reboot a device remotely, and restore it to its default settings.
You can check Deep Mode to enable the function. After that, all the face credentials applied to the device will be cleared. Go to Access Group page and click Apply to Device to apply the data in the system to the device.
You can click Configuration to open remote configuration page of the device and set more parameters.
This function should be supported by the device.
You can configure other parameters for the access control device, such as device time, skin-surface temperature and facial recognition mode.
The parameters may vary with different models of devices.
You can view the time zone where the device locates and set the following parameters.
Set Temperature Screening to on to enable temperature screening function.
Set the range of normal skin-surface temperature. The detected temperature which is not in this range is abnormal temperature. The maximum temperature should be higher than the minimum temperature.
If enabled, the door will open when person's skin-surface temperature is abnormal. By default, the door will not open for abnormal temperature.
Enter the device IP address of the linked thermal camera for temperature screening.
It is used for the access control devices that do not support temperature screening.
Set Mask Detection to on to enable mask detection function. Then the device can detect persons with no masks.
You can configure passing mode for the turnstile linked to the device.
The device will follow the lane controller's DIP settings to control the turnstile. The settings on the main controller will be invalid.
The device will follow the settings of main controller to control the turnstile. The DIP settings of the lane controller will be invalid.
You can reboot a device remotely, and restore it to its default settings.
You can check Deep Mode to enable the function. After that, all the face credentials applied to the device will be cleared. Go to Access Group page and click Apply to Device to apply the data in the system to the device.
You can click Configuration to open remote configuration page of the device and set more parameters.
This function should be supported by the device.