Set Basic Parameters

You can set the device ID, time format, keyboard sound, voice prompt, voice volume, application mode, power saving mode, auto enable supplement light, brightness, and language.

On the Home page, tap System (System Settings) to enter the System Settings page.

Figure 1. Basic Parameters

Table 1. Face Picture Parameters
Parameter	Description
Device ID	Set the face recognition terminal's device ID No. The device ID is the DIP address for the communication between the device and the access controller if the device should connect to an access controller via RS-485 protocol. Note: The device ID should be numbers and should range from 0 to 255.
Time Format	You can select one of the following formats: MM/DD/YYYY, MM.DD.YYYY, DD-MM-YYYY, DD/MM/YYYY, DD.MM.YYYY, YYYYMMDD, YY-MM-DD, YY/MM/DD, and MM-DD-YYYY.
Keyboard Sound	Tap or to disable or enable the keyboard sound.
Voice Prompt	Tap or to disable or enable the voice prompt.
Voice Volume	Adjust the voice volume. The larger the value, the louder the volume.
Application Mode	You can select either others or indoor according to actual environment.
Power Saving Mode	You can enable the power saving mode to save the power consumptions.
Auto Enable Supplement Light	If enabling the function, when the device detects persons in the front, the supplement light will be automatically turned on. If not, the supplement light will be turned off automatically. Note: The distance between the person and the device should be less than 1.3 m, or the supplement light will not turned on automatically.
Brightness	You can set the supplement light's brightness. The brightness ranges from 0 to 100. 0 refers to the supplement light is turned off. 1 refers to the darkest light, and 100 refers to the brightest light.
Language	Change the system language. English, Thai, Spanish, and Arabic are available. Note: The system will auto reboot after you change the language.

Set Basic Parameters

You can set the device ID, time format, keyboard sound, voice prompt, voice volume, application mode, power saving mode, auto enable supplement light, brightness, and language.

On the Home page, tap System (System Settings) to enter the System Settings page.

Figure 1. Basic Parameters

Table 1. Face Picture Parameters
Parameter	Description
Device ID	Set the face recognition terminal's device ID No. The device ID is the DIP address for the communication between the device and the access controller if the device should connect to an access controller via RS-485 protocol. Note: The device ID should be numbers and should range from 0 to 255.
Time Format	You can select one of the following formats: MM/DD/YYYY, MM.DD.YYYY, DD-MM-YYYY, DD/MM/YYYY, DD.MM.YYYY, YYYYMMDD, YY-MM-DD, YY/MM/DD, and MM-DD-YYYY.
Keyboard Sound	Tap or to disable or enable the keyboard sound.
Voice Prompt	Tap or to disable or enable the voice prompt.
Voice Volume	Adjust the voice volume. The larger the value, the louder the volume.
Application Mode	You can select either others or indoor according to actual environment.
Power Saving Mode	You can enable the power saving mode to save the power consumptions.
Auto Enable Supplement Light	If enabling the function, when the device detects persons in the front, the supplement light will be automatically turned on. If not, the supplement light will be turned off automatically. Note: The distance between the person and the device should be less than 1.3 m, or the supplement light will not turned on automatically.
Brightness	You can set the supplement light's brightness. The brightness ranges from 0 to 100. 0 refers to the supplement light is turned off. 1 refers to the darkest light, and 100 refers to the brightest light.
Language	Change the system language. English, Thai, Spanish, and Arabic are available. Note: The system will auto reboot after you change the language.