Set Manual Attendance

Set the attendance mode as manual, and you can select a status manually when you take attendance on the device.

Add at least one person, and set the person's authentication mode. For details, see Person Management.

Click Access Control > Advanced Function > More Parameters to enter the More Parameters page.
Select a device from the left panel.
Click Attendance Status.
Set the attendance mode as Manual.
Make sure Attendance Status Required is enabled.

Note:
By default, Attendance Status Required is enabled.
Set shortcut key from the drop-down list for the attendance status.
Click Save.

Press a key on the device keypad to select an attendance status and authenticate. The authentication will be marked as the configured attendance status according to the defined shortcut key.

Or when you authenticate on the device initial page, you will enter the Select Status page. Select a status to take attendance.

Note:

If you do not select a status for about 20 s, the authentication will be failed and it will not be marked as a valid attendance.