You can set the access control device's Wiegand channel and the communication mode. After setting the Wiegand parameters, the device can connect to Wiegand card reader via Wiegand communication.

1. Enter the Access Control module.
2. On the navigation bar on the left, enter Advanced Function > More Parameters.
3. Select an access control device in the device list and click Wiegand to enter the Wiegand Settings page.
4. Set the switch to on to enable the Wiegand function for the device.
5. Select the Wiegand channel No. and the communication mode from the drop-down list.
   Note:

   If you set Communication Direction as Sending, you are required to set the Wiegand Mode as Wiegand 26 or Wiegand 34.

6. Click Save.

   • The configured parameters will be applied to the device automatically.

   • After changing the communication direction, the device will reboot automatically.