You can set multiple first persons for one access control point. After the first person is authorized, it allows multiple persons access the door or other authentication actions.

1. Click Access Control > Advanced Function > First Person In to enter the First Person In page.
2. Select an access control device in the list on the left panel.
3. Select the current mode as Enable Remaining Open after First Person, Disable Remaining Open after First Person, or Authorization by First Person from the drop-down list for each access control point of the selected device.

   Enable Remaining Open after First Person

   The door remains open for the configured time duration after the first person is authorized until the remain open duration ends. If you select this mode, you should set the remain open duration.

   Note:

   The remain open duration should be between 0 and 1440 minutes. By default, the remain open duration is 10 minutes.

   Disable Remaining Open after First Person

   Disable the function of first person in, namely normal authentication.

   Authorization by First Person

   All authentications (except for the authentications of super card, super password, duress card, and duress code) are allowed only after the first person authorization.

   Note:

   You can authenticate by the first person again to disable the first person mode.

4. Click Add on the First Person List panel.
5. Select person(s) in the left list and the person(s) will be add to the selected persons as the first person(s) of the doors.

   The added first person(s) will list in the First Person List

6. Optional: Select a first person from the list and click Delete to remove the person from the first person list.
7. Click Save.