After adding the access control device, you can configure its access point (door or floor) parameters.

1. Click Access Control > Advanced Function > Device Parameter.
2. Select an access control device on the left panel, and then click to show the doors or floors of the selected device.
3. Select a door or floor to show its parameters on the right page.
4. Edit the door or floor parameters.
   Note:

   • The displayed parameters may vary for different access control devices.

   • Some of the following parameters are not listed in the Basic Information page, click More to edit the parameters.

   Name

   Edit the card reader name as desired.

   Door Contact

   You can set the door sensor as remaining closed or remaining open. Usually, it is remaining closed.

   Exit Button Type

   You can set the exit button as remaining closed or remaining open. Usually, it is remaining open.

   Door Locked Time

   After swiping the normal card and relay action, the timer for locking the door starts working.

   Extended Open Duration

   The door contact can be enabled with appropriate delay after person with extended accesss needs swipes her/his card.

   Door Left Open Timeout Alarm

   The alarm can be triggered if the door has not been closed in a configured time period. If it is set as 0, no alarm will be triggered.

   Lock Door when Door Closed

   The door can be locked once it is closed even if the Door Locked Time is not reached.

   Duress Code

   The door can open by inputting the duress code when there is duress. At the same time, the client can report the duress event.

   Super Password

   The specific person can open the door by inputting the super password.

   Dismiss Code

   Create a dismiss code which can be used to stop the buzzer of the card reader (by entering the dismiss code on the keypad).

   Note:

   • The duress code, super code, and dismiss code should be different.

   • The duress code, super password, and the dismiss code should be different from the authentication password.

   • The length of duress code, super password, and the dismiss code is according the device, usually it should contains 4 to 8 digits.

5. Click OK.
6. Optional: Click Copy to , and then select the door/floor(s) to copy the parameters in the page to the selected doors/floor(s).
   Note:

   The door or floor's status duration settings will be copied to the selected door/floor(s) as well.