After adding the access control device, you can configure its parameters, including overlaying user information on picture, uploading pictures after capturing, saving captured pictures, etc.

1. Click Access Control > Advanced Function > Device Parameter.
   Note:

   If you can find Device Parameter in the Advanced Function list, Hover the cursor on the Advanced Function, and then Click to select the Device Parameter to be displayed.

2. Select an access device to show its parameters on the right page.
3. Turn the switch to ON to enable the corresponding functions.
   Note:

   • The displayed parameters may vary for different access control devices.

   • Some of the following parameters are not listed in the Basic Information page, click More to edit the parameters.

   RS-485 Comm. Redundancy

   You should enable this function if you wire the RS-485 card reader to the access control device redundantly.

   Display Detected Face

   Display face picture when authenticating.

   Display Card Number

   Display the card information when authenticating.

   Display Person Information

   Display the person information when authenticating.

   Overlay Person Info. on Picture

   Display the person information on the captured picture.

   Voice Prompt

   If you enable this function, the voice prompt is enabled in the device. You can hear the voice prompt when operating in the device.

   Upload Pic. After Linked Capture

   Upload the pictures captured by linked camera to the system automatically.

   Save Pic. After Linked Capture

   If you enable this function, you can save the picture captured by linked camera to the device.

   Press Key to Enter Card Number

   If you enable this function, you can input the card No. by pressing the key.

   Wi-Fi Probe

   If you enable this function, the device can probe the surrounding communication devices' MAC address and upload the MAC address to the system. If the MAC address match the specified MAC address, the system can trigger some linkage actions.

   3G/4G

   If you enable this function, the device can communicate in 3G/4G network.

4. Click OK.
5. Optional: Click Copy to, and then select the access control device(s) to copy the parameters in the page to the selected device(s).