After adding the lane controller to the client, you can configure its parameters for passing through the lane.

1. Click Access Control > Advanced Function > Device Parameter to enter Parameter Settings page.
2. In the device list on the left, select a lane controller and you can edit the lane controller's parameters on the right.
3. Edit the parameters.

   Passing Mode

   Select the controller which will control the barrier status of the device.

   • If you select According to Lane Controller's DIP Settings, the device will follow the lane controller's DIP settings to control the barrier. The settings on the software will be invalid.

   • If you select According to Main Controller's Settings, the device will follow the settings of the software to control the barrier. The DIP settings of the lane controller will be invalid.

   Free Passing Authentication

   If you enable this function, when both entrance and exit's barrier mode is Remain Open, the pedestrians should authenticate each time passing through the lane. Or an alarm will be triggered.

   Opening/Closing Door Speed

   Set the barrier's opening and closing speed. You can select from 1 to 10. The greater the value, the faster the speed.

   Note:

   The recommended value is 6.

   Audible Prompt Duration

   Set how long the audio will last, which is played when an alarm is triggered .

   Note:

   0 refers to the alarm audio will be played until the alarm is ended.

   Temperature Unit

   Select the temperature unit that displayed in the device status.

4. Click OK.