Configure Anti-Passback

Configure Anti-Passback

You can set to only pass the access control point according to the specified path and only one person could pass the access control point after swiping the card.

Enable the anti-passing back function of the access control device.

Perform this task when you want to configure the anti-passing back for the access control device.

Note:

Either the anti-passing back or multi-door interlocking function can be configured for an access control device at the same time. For the configuration of multi-door interlocking, refer to Configure Multi-door Interlocking.

  1. Click Access Control > Advanced Function > Anti-Passback to enter the Anti-Passpack Settings page.
  2. Select an access control device on the left panel.
  3. Select a card reader as the beginning of the path in the First Card Reader field.
  4. Click of the selected first card reader in the Card Reader Afterward column to open the select card reader dialog.
  5. Select the afterward card readers for the first card reader.
    Note:

    Up to four afterward card readers can be added as afterward card readers for one card reader.

  6. Click OK in the dialog to save the selections.
  7. Click Save in the Anti-Passback Settings page to save the settings and take effect.

Set Card Swiping Path

If you select Reader In_01 as the beginning, and select Reader In_02, Reader Out_04 as the linked card readers. Then you can only get through the access control point by swiping the card in the order as Reader In_01, Reader In_02 and Reader Out_04.

Configure Anti-Passback

You can set to only pass the access control point according to the specified path and only one person could pass the access control point after swiping the card.

Enable the anti-passing back function of the access control device.

Perform this task when you want to configure the anti-passing back for the access control device.

Note:

Either the anti-passing back or multi-door interlocking function can be configured for an access control device at the same time. For the configuration of multi-door interlocking, refer to Configure Multi-door Interlocking.

  1. Click Access Control > Advanced Function > Anti-Passback to enter the Anti-Passpack Settings page.
  2. Select an access control device on the left panel.
  3. Select a card reader as the beginning of the path in the First Card Reader field.
  4. Click of the selected first card reader in the Card Reader Afterward column to open the select card reader dialog.
  5. Select the afterward card readers for the first card reader.
    Note:

    Up to four afterward card readers can be added as afterward card readers for one card reader.

  6. Click OK in the dialog to save the selections.
  7. Click Save in the Anti-Passback Settings page to save the settings and take effect.

Set Card Swiping Path

If you select Reader In_01 as the beginning, and select Reader In_02, Reader Out_04 as the linked card readers. Then you can only get through the access control point by swiping the card in the order as Reader In_01, Reader In_02 and Reader Out_04.