Install with Gang Box

Install with Gang Box

  1. According to the datum line on the mounting template, stick the mounting template on the wall or other surface, 1.4 meters higher than the ground.
    Figure 1. Mounting Template
  2. Drill holes on the wall or other surface according to the mounting template and install the gang box (80 mm × 80 mm).
  3. Use two supplied screws to secure the mounting plate on the gang box.
  4. Use another four supplied screws to secure the mounting plate on the wall.
  5. Route the cables through the cable hole of the mounting plate, and connect to the corresponding external devices' cables.
  6. Cover the interfaces with the supplied back sheet and secure the sheet with three screws.
    Note:

    Apply Silicone sealant among the wiring hole to keep the raindrop from entering.

    Figure 2. Device Back Sheet
  7. Remove the screw at the bottom of the device.
  8. Align the device with the mounting plate and buckle them together.
  9. Use a hex wrench to fasten the screw at the bottom.
    Note:

    • The installation height here is the recommended height. You can change it according to your actual needs.

    • You can also install the device on the wall or other places without the gang box. For details, see Installing without Gang Box.

    • For easy installation, drill holes on mounting surface according to the supplied mounting template.

    Figure 3. Install with Gang Box

Install with Gang Box

  1. According to the datum line on the mounting template, stick the mounting template on the wall or other surface, 1.4 meters higher than the ground.
    Figure 1. Mounting Template
  2. Drill holes on the wall or other surface according to the mounting template and install the gang box (80 mm × 80 mm).
  3. Use two supplied screws to secure the mounting plate on the gang box.
  4. Use another four supplied screws to secure the mounting plate on the wall.
  5. Route the cables through the cable hole of the mounting plate, and connect to the corresponding external devices' cables.
  6. Cover the interfaces with the supplied back sheet and secure the sheet with three screws.
    Note:

    Apply Silicone sealant among the wiring hole to keep the raindrop from entering.

    Figure 2. Device Back Sheet
  7. Remove the screw at the bottom of the device.
  8. Align the device with the mounting plate and buckle them together.
  9. Use a hex wrench to fasten the screw at the bottom.
    Note:

    • The installation height here is the recommended height. You can change it according to your actual needs.

    • You can also install the device on the wall or other places without the gang box. For details, see Installing without Gang Box.

    • For easy installation, drill holes on mounting surface according to the supplied mounting template.

    Figure 3. Install with Gang Box