You can configure card swiping parameters to allow authentication by inputting card number on keypad, eanble NFC anti-cloning, and Mifare encryption.

1. Click Physical View on the Home page, and then select Access Control Device.
2. Click to enter the remote configuration page and go to the Card Swiping section.
3. Configure card swiping parameters.
   Note:

   The parameters vary with different models of access control devices.

   Input Card Number On Keypad

   If checked, visitors are allowed to input card number on keypad to authenticate their identities.

   Enable NFC Card

   If enabled, visitors cannot use the cloned cards for authentication.

   Mifare Encryption

   If enabled, only the card with the same encrypted sector can be granted by swiping the card on the card reader.

   Voice Prompt

   If you enable this function, the voice prompt will be enabled on the device. You can hear the voice prompt when operating on the device.

   Upload Picture after linked Capture

   Upload the pictures captured by the camera(s) which related to the door(s) under the access control device to the system automatically.

   Note:

   You can relate a camera to a door in the Logical View module. For details, see Edit Door for Current Site.

   Picture Storage

   If checked, the captured picture(s) will be automatically saved to the storage location you configured in picture storage settings for the door(s) under the access control device.

   Note:

   For details about configuring picture storage settings for doors, see Edit Door for Current Site.

   Picture Size

   Select a picture size from the drop-down list for the captured picture(s) saved to the storage location.

   Picture Quality

   Select a picture quality from the drop-down list for the captured picture(s) saved to the storage location.