You can set sound settings, time settings, sleeping (s), community No., building No., Unit No., beauty, privacy, authentication indicator, video standard and secure door control unit.
Long tap on the initial page for 3 s and slide to the left/right by following the gesture and login the device home page. Tap .
You can enable/disable the voice prompt function and adjust the voice volume.
You can set the voice volume between 0 and 10.
Set the time zone, the device time and the DST.
Set the device sleeping waiting time (minute). When you are on the initial page and if you set the sleeping time to 30 min, the device will sleep after 30 min without any operation.
If you set the sleeping time to 0, the device will not enter sleeping mode.
Select the language according to actual needs.
Set the device installed community No.
Set the device installed building No.
Set the device installed unit No.
You can enable the beauty function and set the smooth and the whiten parameter. Tap + or - to control the effect strength.
By default, the function is disabled.
You can choose to display/not display/desensitize name and Employ ID when authenticating.
You can choose to display/not display face picture when authenticating.
The registered face picture will be saved to the system if you enable the function.
If you enable this function, you can save the picture after linked capture.
Upload the pictures captured after linked capture.
If you enable this function, you can save the picture when authenticating to the device.
Upload the pictures captured when authenticating to the platform automatically.
Upload the pictures captured during call to the platform automatically.
The white indicator is disabled by default. If white indicator is enabled , the indicators of other colors will eventually cut to the white indicator; If white indicator is disabled, the indicators of other colors will eventually go out. You can set brightness and mode.
If you enable Red and Green Indicator, when the authentication is successful, the green indicator will continue to light for 2 seconds; When authentication fails, the red indicator flashes 3 times. When authentication continues, the green indicator continues to flash until the authentication ends.
Set the video frame rate when performing live view remotely. After changing the standard, you should reboot the device to take effect.
You can select door and view secure door control unit status. Selecting door 1 means that the door will be controlled by secure door control unit. The same goes to the selection of door 2.