Call Client Software from Device

  1. Get the client software from the supplied disk or the official website, and install the software according to the prompts.
  2. Run the client software and the control panel of the software pops up.
  3. Click Device Management to enter the Device Management interface.
  4. Add the device to the client software.
    Note:

    For details about adding device, see Add Device.

  5. Call the client software.
    1. Tap on the device initial page.
    2. Enter 0 in the pop-up window.
    3. Tap to call the client software.
  6. Tap Answer on the pop-up page of the client software and you can start two-way audio between the device and the client software.
    Note:

    If the device is added to multiple client softwares and when the device is calling the client software, only the first client software added the device will pop up the call receiving window.