Keyfob Management

You can add keyfobs to the security control panel to remotely control the area of the panel.

1. On the device list page, tap the security control panel and then log in to the device (if required) to enter the area page.
   Note:

   If EN50131 Compliant mode is enabled, you should log in to the security control panel before you can configure it. For details about enabling EN 50131 Compliant mode, see EN50131 Compliant Mode.

2. Tap and then tap Add Keyfob on the Scan QR Code page.
3. Present the keyfob to the security control panel.
4. Press any button on the keyfob to learn.
5. Create a keyfob name.
   Note:

   • If you log in as an installer, skip this step.

   • The keyfob name should contain 1 to 32 characters.

6. Select area(s) to be linked to the keyfob.
   Note:

   If you log in as an installer, skip this step. Selecting area is only available for the administrator.

   You can remotely control the selected area(s) by the keyfob based on the permission(s) configured in step 8.

7. Set the Enable Keyfob switch to on to enable the keyfob.
   Note:

   If you log in as an installer, skip this step. Enabling keyfob is only available for the administrator.

8. Select permissions (such as the permission to disarm and clear alarm) for the keyfob to define what operations can be done via keyfob.
   Note:

   If you log in as an installer, skip this step. Setting permissions for keyfob is only available for administrator.

9. Tap Add.
10. Optional: Enable silent panic alarm.
    1. Go to the settings page of the keyfob.
    2. Enable Silent Panic Alarm.

       When enabled, no linked alarm output (e.g., sound prompt) will be triggered when panic alarms of the keypad is triggered.