Set Parameters of Wireless Outputs Expander

You can set the alarm output type and the output delay for the relays of a wireless outputs expander. Alarm output is the node signal or other signal sent from the alarm controller to the peripheral devices when the alarm is triggered.

Make sure you have added wireless outputs expander(s) to the security control panel.

  1. On the device list page, tap the security control panel and then log in to the device (if required) to enter the Area page.
    Note:

    If EN50131 Compliant mode is enabled, you should log in to the security control panel first before you can configure the device. For details about enabling EN50131 Compliant mode, see EN50131 Compliant Mode.

  2. Tap Peripheral Device and then tap a wireless outputs expander on the device list.

    The name of the module and the relays of the expander will be displayed.

  3. Click the name of the module to set its parameter.
    Offline Duration

    If the time during which the wireless outputs expander loses communication with the security control panel exceeds the configured offline duration, the wireless outputs expander will be regarded as offline.

    Note:

    The default offline duration is 1 hour.

  4. Tap a relay to enter its settings page to set its parameters.
    Continuous Output

    If enabled, the relay will be normally closed or open.

    Output Delay

    The delay time for the relay to become closed. In other words, output delay refers to the duration of the alarm output.

    Link Event

    Set the type of the event linked to the relay.

    Alarm

    Alarm outputs will be activated when the zones in the selected area(s) alarm.

    You can select an event sub-type (e.g, panic alarm) as the event that requires alarm output once it is detected within the zones.

    Arming

    Alarm outputs will be activated when the area(s) you select are armed.

    Disarming

    Alarm outputs will be activated when the selected area(s) are disarmed.

    Manual Mapping

    Set the switch icon to ON to manually activate alarm outputs of the relay.

    Zone

    Alarm outputs will be activated when the selected zone(s) are triggered or tampered.