Set Wireless Keypad Parameters

You can set the wireless keypad parameters, including device name, buzzer, card/tag swiping, backlight, and security settings, etc.

1. On the device list page, tap the security control panel and then log in to the device (if required) to enter the Area page.
   Note:

   If EN50131 Compliant mode is enabled, you should log in to the security control panel first before you can configure the device. For details about enabling EN50131 Compliant mode, see EN50131 Compliant Mode.

2. Tap Peripheral Device and then tap a wireless keypad on the device list.
3. Set the parameters.

   Linked Area

   Set the area linked to the keypad. The linked area can be arm/disarm or clear alarm by the keypad.

   Buzzer

   Enable the buzzer.

   Card/Tag Swiping

   Enable swiping card/tag on the keypad to arm/disarm the linked area or clear alarms.

   Keypad

   Enable using keypad to arm/disarm the linked area or clear alarms.

   Backlight

   Enable the backlight of the keypad.

   Offline Duration

   If the time during which the keypad loses communication with the security control panel exceeds the configured offline duration, the keypad will be regarded as offline.

   Silent Panic Alarm

   When enabled, no linked alarm output (e.g., sound prompt) will be triggered when panic alarms of the keypad is triggered.

   Security Settings

   Locked Duration

   Specify the duration that the keypad remains locked if the failed keypad password attempts reach the specified maximum times.

   Maximum Failed Attempts

   Specify the maximum failed attempts for entering the incorrect keypad password consecutively. If the failure times reaches the specified value, the keypad will remain locked for a specified duration.