Set Wireless Siren Parameters

You can edit the name of the wireless siren and set the siren's volume.

Make sure you have added wireless siren(s) to the security control panel. For details, see Add Device to the Security Control Panel.

  1. On the device list page, tap the security control panel and then log in to the device (if required) to enter the Area page.
    Note:

    If EN50131 Compliant mode is enabled, you should log in to the security control panel first before you can configure the device. For details about enabling EN50131 Compliant mode, see EN50131 Compliant Mode.

  2. Tap Peripheral Device and then tap a siren on the device list to enter the siren settings page.
  3. Perform the following operations.
    Option Description

    Edit Siren Name

    Tap the siren name to edit it, and then tap .

    Set Siren Volume

    Drag the slider to set the volume.

    Note:

    The function should be supported by the siren.
  4. Set parameters.
    Offline Duration

    If the time during which the siren loses communication with the security control panel exceeds the configured offline duration, the siren will be regarded as offline.

    Arm/Disarm LED Indicator

    If enabled, the LED indicator of the siren will flash for one time when an area is armed, two times when disarmed.

    Note:

    For sirens of the versions earlier than V1.0.6, the parameter is not supported.

    Arm/Disarm Buzzer

    If enabled, the buzzer of siren will buzz for one time when an area is armed, two times when disarmed.

    Note:

    For sirens of the versions earlier than V1.0.6, the parameter is not supported.

    Volume Test

    Tap to test the volume of the siren.

    Note:

    For sirens of the versions earlier than V1.0.6, the parameter is not supported.