Set Wireless Card/Tag Reader Parameters

You can set the wireless card/tag reader parameters, including device name, linked area, buzzer, offline duration, and security settings.

1. On the device list page, tap the security control panel and then log in to the device (if required) to enter the Area page.
   Note:

   If EN50131 Compliant mode is enabled, you should log in to the security control panel first before you can configure the device. For details about enabling EN50131 Compliant mode, see EN50131 Compliant Mode.

2. Tap Peripheral Device and then tap a wireless keypad on the device list.
3. Set the parameters.

   Linked Area

   Set the area linked to the wireless card/tag reader. The linked area can be arm/disarm or clear alarm by swiping card/tag on the card/tag reader.

   Buzzer

   Enable the buzzer of the card/tag reader.

   Offline Duration

   If the time during which the siren loses communication with the security control panel exceeds the configured offline duration, the siren will be regarded as offline.

   Security Settings

   Locked Duration

   Specify the duration that the card/tag reader remains locked if the failed card/tag swiping attempts reach the specified maximum times.

   Maximum Failed Attempts

   Specify the maximum failed attempts for swiping card/tag. If the failure times reaches the specified value, the card/tag reader will remain locked for a specified duration.