Add Card/Tag

After adding cards or tags to the security control panel, you can swipe the card/tag to arm or disarm all the detectors added to specific area(s) of the security control panel, or clear alarms.

1. On the device list page, tap the security control panel and then log in to the device (if required) to enter the area page.
2. Tap > User Management > Card/Tag Management > Add New Card/Tag to enter the Card/Tag Management page.
3. Select a keypad.
4. When hearing the voice prompt "Swipe Card", you should present the card/tag on the control panel card presenting area.

   When hearing a beep sound, the card/tag is recognized.

5. Create a card/tag name.
   Note:

   • If you log in as an installer, skip this step. Editing card/tag name is only available to the administrator.

   • The name should contain 1 to 32 characters.

   The card/tag will be displayed on the Card/Tag Management page.

6. Select area(s) to be linked to the card/tag.
   Note:

   If you log in as an installer, skip this step. Selecting area is only available for the administrator.

   You can remotely control the selected area(s) by the card/tag based on the permission(s) configured in step 8.

7. Set the Enable Card/Tag switch to on to enable the card/tag.
   Note:

   If you log in as an installer, skip this step. Enabling card/tag is only available for the administrator.

8. Select permissions (such as the permission to disarm and clear alarm) for the card/tag to define what operations can be done via card/tag.
   Note:

   If you log in as an installer, skip this step. Setting permissions for card/tag is only available for the administrator.

9. Tap Add.