Configure Other Parameters

You can configure other parameters for an access control device, such as device time and turnstile parameters.

Note:

Device support required. Parameters vary with different device types and models.

Time

You can view the time zone where the device locates and set the following parameters.

Device Time: Click the Device Time field to customize time for the device.
Sync with Server Time: Synchronize the device time with the server of the platform.

Biometrics

You can enable facial recognition and fingerprint recognition of access control devices if the devices support biometrics recognition.

Facial Recognition

Set facial recognition function for the device, and select a facial recognition mode.

Single-Person Recognition: The device can recognize one person at a time.
Multiple-Person Recognition: The device can recognize multiple persons at a time.

Fingerprint Recognition

Set persons' fingerprint recognition for the device. Once enabled, the device can recognize persons by their fingerprints.

Skin-surface Temperature

Set Temperature Screening to on to enable temperature screening function.

Threshold(℃): Set the range of normal skin-surface temperature. The detected temperature that is not in this range is abnormal temperature. The maximum temperature should be higher than the minimum temperature.
Open Door When Temperature is Abnormal: If it is enabled, the door will open when person's skin-surface temperature is abnormal. By default, the door will not open for abnormal temperature.
Linked Thermal Camera: Enter the device IP address of the linked thermal camera for temperature screening.

Note:
It is used for the access control devices that do not support temperature screening.

Mask Settings

Set Mask Detection to on to enable mask detection function. Once enabled, the device can detect persons without face masks.

Do Not Open Barrier when No Mask: If it is checked, the barrier will still open for persons without masks.

RS-485

RS-485 Communication Redundancy: You can check RS-485 Communication Redundancy to enable the function if you wire the RS-485 card to the device redundantly.
Working Mode: Select the working mode, including the card reader, door control unit, and access control host.

Turnstile Parameters

You can configure passing mode for the turnstile linked to the device.

Based on Lane Controller's DIP Mode: The device will follow the lane controller's DIP settings to control the turnstile. The settings on the main controller will be invalid.
Based on Main Controller's Settings: The device will follow the settings of main controller to control the turnstile. The DIP settings of the lane controller will be invalid.

Maintenance

You can reboot a device remotely and restore it to its default settings.

Reboot: Reboot the device.
Restore Default Settings: Restore the device to its default settings. The device needs to be activated after being restored.

Facial Recognition Mode

You can check Deep Mode to enable the function. Once enabled, all the face credentials applied to the device will be cleared. Go to Access Control > Access Level and click to apply the data in the platform to the device.

You can click Configure to open the remote configuration page of the device and configure more parameters. For details, refer to the user manual of the device.