Set Wiegand Parameters

You can set Wiegand parameters for access control devices to facilitate communications between card readers and access control devices.

1. In the top left corner of Home page, select > Basic Management > Device.
2. Click Device and Server > Access Control Device on the left panel.
3. Click in the Operation column to enter the configuration page of an access control device.
4. Set Wiegand parameters.
   1. Select a Wiegand protocol in the list, and click in the Operation column to pop up a window of Wiegand information.
   2. On the pop-up window, set Wiegand parameters.

      Direction

      Whether the device is used for inputting (receiving) or outputting (sending) data.

      Check Input or Output.

      Wiegand Mode

      The signal transmitting mode. Whether the device transmits 26-bit or 34-bit data.

      Note:

      Wiegand mode can only be selected when the direction is Output.

      Output Format

      Whether to output the signal as employee No. or card No.

      Note:

      Output format can only be selected when the direction is output.

      Signal Sending Interval

      The interval of sending data.

      Linked Card Reader

      The card reader No. to be linked.

      Note:

      Linked card reader can only be selected when the device supports linking to a card reader.

5. Click OK to save the parameters.