Edit Alarm Input for Current Site

You can edit the basic information of alarm input and relate detector to the security control panel's alarm input for current site.

  1. In the top left corner of Home page, select > Basic Management > Device.
  2. Click Area on the left.
  3. In the area list panel, select the added current site from the drop-down site list to show its areas.
    Note:

    The icon indicates that the site is current site.

  4. Optional: Select an area.
  5. Select the Alarm Input tab to show the added alarm inputs.
  6. Click an alarm input name in the Name column to enter the Edit Alarm Input page.
  7. Edit the alarm input name.
  8. Optional: For the alarm input of security control panel, set the Related Detector switch to ON to configure related detector for the alarm input.
    1. Click Add to add a detector.
    2. Enter the detector name.
    3. Click to save the detector type.
    Note:

    • Only the alarm input of a security control panel supports this function. Make sure you have added a security control device to the system, and have added its zone to area as an alarm input. See Add Alarm Input to Area for Current Site for details.

    • On Map Settings page, the detectors related to the alarm input of a security control panel will be displayed in the resource list of alarm input on the right panel. When selecting the alarm input and dragging it to the map, the related detectors will also be added to the map, and the relations among them will be marked with lines. If you only drag the alarm input to the map without selecting it, the related detectors will not be added to the map.

    • You cannot edit the detector type here. If you want to edit it, go to the Remote Configuration page of security control panel, and click Input Settings > Zone.

  9. Click Save.