Control Video Wall
You can control the video walls after adding them to the platform.
-
Make sure you have added video walls. See details in Configure Video Wall.
-
The multiple terminals that constitute the video wall should be controlled as a whole, or the playing status of different terminals will not be the same.
On the top navigation
bar, select 
> Integrated Service > Digital Signage, and then click on the left navigation pane.
Operations When No Video Wall Is Selected
- Switch Display Mode
-
Click
/
to display the added video walls in thumbnail/list mode. - Refresh Video Wall List
-
Click Refresh to refresh the video wall list.
- Search Video Walls
-
Click
, set the search conditions (dimension,
screen type, network status, play status, cut-in status, etc.,), and click
Search to search for the target video walls.
Operations After Selecting Video Wall(s)
- Start Up / Shut Down / Reboot
-
Remotely start up, shut down, or reboot the video walls.
- Play/Stop
-
Play or stop the programs on the video walls.
- Volume
-
Set the volume of the video walls.
- Stop Cut-In
-
Stop cutting in programs.
- Clear Playing Content
-
Clear all contents to be played on the video walls.
- Timed Startup/Shutdown Enabled/Disabled
-
Enable or disable startup/shutdown according to the schedule.
Note:For details about timed startup/shutdown, see details in Configure Device Display Settings.
- Timed Volume On/Off
-
Turn on/off the volume of the video walls based on the configured schedule.
Note:For details about timed volume on/off, see details in Configure Device Display Settings.
- NTP Time Sync.
-
The time synchronization of NTP server should be enabled when starting synchronous playing on the terminals. See details in Set NTP.
- Restore Default
-
Restore the parameters of the terminals to the default settings.