Configure Device Parameters

After adding the video intercom devices, you can configure parameters for them remotely, including device time, maintenance settings, etc.

After adding a video intercom device, click in the Operation column to configure the device.

Note:

The parameters may vary with different models of devices.

Time

You can view the time zone where the device locates and set the following parameters.

Device Time: Click Device Time field to customize time for the device.
Sync with Server Time: Synchronize the device time with that of the SYS server of the system.

Call Management Center

For door station, you can set this function switch to on and select a shortcut button. When the configured button on the device is pressed, it will call management center. The default button is 1.

Note:

This should be supported by the device.

Card Swiping

For outer door station and door station which supports M1 encryption, you can enable M1 Encryption and select the sector. Only the card with the same encrypted sector can be granted by swiping the card on the card reader.

Related Cameras

For indoor station, you can relate the camera(s) with it to view the video of the related camera(s) on the indoor station. You can also delete the related camera(s). Up to 16 related cameras are supported.

Maintenance

You can reboot a device remotely, and restore it to its default settings.

Reboot: Reboot the device.
Restore Default: Restore the device to its default settings. The device should be activated after restoring.