Configure Auto-Switch Full Screen Monitoring

When an alarm is triggered, the local monitor displays in full screen the video image from the alarming channel configured for full screen monitoring. And when the alarm is triggered simultaneously in several channels, you must configure the auto-switch dwell time.

Note:

Auto-switch will terminate once the alarm stops and back to the live view interface.

  1. Go to System > Live View > General.
  2. Set the event output and dwell time.
    Event Output

    Select the output to show the event video.

    Full Screen Monitoring Dwell Time

    Set the time in seconds to show the alarm event screen. If alarms are triggered simultaneously in several channels, their full-screen images will be switched at an interval of 10 seconds (default dwell time).

  3. Go to the Linkage Action interface of the alarm detection (e.g., motion detection, video tampering, face detection, etc.).
  4. Select the Full Screen Monitoring alarm linkage action.
  5. Select the channel(s) in Trigger Channel for full screen monitoring.