Set NTP for Time Synchronization

You can set NTP parameters for synchronizing the time between resources managed on the platform and the NTP server.

1. Select NTP on the left navigation bar.
2. Select the Time Sync Mode.
   Note

   For time synchronization via network and the local server, just set the synchronization interval and click Save. For time synchronization via the NTP server, follow steps below.

3. Set the NTP server address and port No.
   Note

   If the local NTP server has been configured, click Detect Local NTP to fill in the NTP server address and port No. automatically.

4. Enter the interval of the automatic time synchronization.
5. Optional: Click Test to test the communication between resources and the NTP server.
6. Optional: Switch on Configure WAN Mapping and enter the IP address and port No. for WAN mapping.
   Note

   If the NTP service is locally deployed, you can configure WAN mapping to synchronize the time for devices on the WAN. Otherwise, enabling mapping is not required.

7. Click Save.